Speedtouch 580 firmware update




















USB port type:. Rate limiting:. NAT routing:. Port forwarding:. Port forwarding of ranges:. Port triggering:. DHCP server:. DHCP client:. DHCP relay:. DNS proxy:. Dynamic DNS client:. Routing Protocols:.

DSL compliance:. ADSL1 G. PPPoE client:. PPPoA client:. DSL Line condition view:. Maximum Wireless Speed:. WiFi standards supported:. Access point. Default SSID:. Multiple SSID:.

WDS compatible:. SPI firewall:. Security log:. Device Management. Default IP address:. Default admin username:. Default admin password:. Firmware upgradeable:. Once you have entered the details, click OK to continue, If this stage is skipped the wizard will have used the default username of Administrator and a blank password. The wizard will now display information for the router it has detected on your network.

Once you have confirmed this is the router you wish to upgrade you must select a firmware image to update the router with. As standard the wizard will have no firmware images available in the list above. To continue click Have Disk.

Click Browse to locate the new firmware upgrade file. Browse to the location where you saved the firmware file. File names will vary depending on the router and firmware you are using.

Once you have selected the firmware file click Open. The wizard will now check that the file is a valid firmware image to update the router with. The list will now contain the details of the firmware the that wizard will use. Once you confirm that this is the firmware you want to use click Next to continue.

The upgrade process may take some time. Please do not disconnect the router during this period. If the upgrade fails wait two minutes for the router to restart then click Back until you reach the start the upgrade process again. The wizard will now confirm that the upgrade has been completed. You may now click Close. Rate this Article:. Feedback on this Article. Comment require login or registration.



0コメント

  • 1000 / 1000